Texas Instruments TPS62366AEVM-757 Evaluation Module TPS62366AEVM-757 TPS62366AEVM-757 Datenbogen
Produktcode
TPS62366AEVM-757
Software Setup and Operation
3
Software Setup and Operation
This section provides descriptions of the EVM software and functionality.
The supplied software is used to communicate with the TPS62366AEVM. Click on the icon on the host PC
to start the software. The host PC software first checks the firmware version of the USB-TO-GPIO
adapter. If an incorrect firmware version is installed, the software automatically searches on the Internet (if
connected) for updates. If a new update is available, the software notifies the user of the update,
downloads and installs the software. Note that after the firmware is updated, the user must disconnect and
then reconnect the USB cable between the adapter and PC, as instructed during the install process. The
host PC software also automatically searches on the Internet (if connected) for updates to the EVM
software. If a new update is available, the software notifies the user of the update, downloads and installs
the update.
to start the software. The host PC software first checks the firmware version of the USB-TO-GPIO
adapter. If an incorrect firmware version is installed, the software automatically searches on the Internet (if
connected) for updates. If a new update is available, the software notifies the user of the update,
downloads and installs the software. Note that after the firmware is updated, the user must disconnect and
then reconnect the USB cable between the adapter and PC, as instructed during the install process. The
host PC software also automatically searches on the Internet (if connected) for updates to the EVM
software. If a new update is available, the software notifies the user of the update, downloads and installs
the update.
V
IN
and V
DD
must be supplied for the software to detect the TPS62366A and run.
The software reads the registers on the TPS62366A and automatically determines which version of the IC
is installed. Even if the IC is disabled via the EN pin (JP3), the user can still communicate with the
TPS62366A if V
is installed. Even if the IC is disabled via the EN pin (JP3), the user can still communicate with the
TPS62366A if V
IN
and V
DD
are supplied. If no IC is detected, the software aborts loading.
The software displays the main panel for the user interface, shown in
Figure 1. TPS62366A Software Main Panel
6
TPS62366AEVM-757
SLVU690 – April 2012
Copyright © 2012, Texas Instruments Incorporated