Texas Instruments DRV603EVM - DRV603 Evaluation Module DRV603EVM DRV603EVM Datenbogen
Produktcode
DRV603EVM
1.1
DRV603EVM Features
Input
On/Off
Right
Right
Digital
Left
Left
DIR9001
PCM1793
+7 V
Linear
Regulator
DRV603
Output
2
Quick Setup
www.ti.com
Quick Setup
Throughout this document, the abbreviation EVM and the term evaluation module are synonymous with
the DRV603EVM.
the DRV603EVM.
The DRV603EVM has these features:
•
Two-channel evaluation module (double-sided, plated-through PCB layout)
•
2-V
RMS
line output
•
Single-ended or balanced analog input
•
Digital S/PDIF TOSLINK input
•
No output capacitor required
•
Shutdown button
illustrates the functional diagram for the EVM.
summarizes the key parameters.
Figure 1. DRV603EVM Functional Block Diagram
Table 1. Key Parameters
Key Parameters
Specification/Unit
Supply Voltage
7 V
Number of Channels
Two
Load Impedance
2.5 k
Ω
(min)
Output Voltage
3 V
RMS
Dynamic Range: Analog Input
> 112 dB
Dynamic Range: Digital Input
> 108 dB
This section describes the DRV603EVM board with regard to the power supply and system interfaces. It
provides information about handling and unpacking the DRV603EVM, absolute operating conditions, and a
description of the factory default switch and jumper configurations.
provides information about handling and unpacking the DRV603EVM, absolute operating conditions, and a
description of the factory default switch and jumper configurations.
The following subsections provide a step-by-step guide to configuring the DRV603EVM for device
evaluation.
evaluation.
SLOU252A – December 2008 – Revised January 2009
DRV603EVM
3