Texas Instruments DRV604PWPEVM - DRV604PWP Evaluation Module DRV604PWPEVM DRV604PWPEVM Datenbogen
Produktcode
DRV604PWPEVM
DVDD
Enable
>50
S
m
>50
S
m
Quick Setup Guide
www.ti.com
2
Quick Setup Guide
This chapter describes the DRV604PWPEVM board in regards to power supply and system interfaces.
The chapter provides information regarding handling and unpacking, absolute operating conditions, and a
description of the factory default switch and jumper configuration.
The chapter provides information regarding handling and unpacking, absolute operating conditions, and a
description of the factory default switch and jumper configuration.
The following is a step-by-step guide to configuring the DRV604PWPEVM for device evaluation.
2.1
Electrostatic Discharge Notice
CAUTION
Failure to observe proper ESD handling procedures may result in damage to
EVM components.
EVM components.
2.2
Unpacking the EVM
On opening the DRV604PWPEVM package, ensure that the following items are included:
•
1 pc. DRV604PWPEVM board using one DRV604PWP.
If either of these items is missing, contact the Texas Instruments Product Information Center nearest you
to inquire about a replacement.
to inquire about a replacement.
2.3
Power-Supply Setup
To power up the EVM one power supply is needed. The power supply is connected to the EVM using a
2pin 2.54mm pin header, J1.
2pin 2.54mm pin header, J1.
Table 2. Recommended Supply Voltage
Description
Voltage Limitations
Current Requirement
Cable
Power supply
5 V
0.1 A
—
CAUTION
Applying voltages above the limitations given in
may cause permanent
damage to your hardware.
3
On/Off Sequence
For minimum click and pop during power on and power off, the DRV604 Enable inputs, pin 5 and pin 10,
should be kept low. The preferred power-up/down sequence is shown in
should be kept low. The preferred power-up/down sequence is shown in
Figure 2. Power-Up/-Down Sequence
4
DRV604PWPEVM
SLOU288 – February 2010
Copyright © 2010, Texas Instruments Incorporated