Texas Instruments TAS5708 Evaluation Module (EVM) TAS5708EVM TAS5708EVM Datenbogen
Produktcode
TAS5708EVM
2.1.2
PSU Interface
www.ti.com
Installation
Figure 4. Connecting TAS5708(TAS5710)EVM to MC57xxPSIA
The TAS5708(TAS5710)EVM is powered by two power supplies connected to the MC57xx controller
board: a 5-V power supply (VIN) and a 10-V to 26-V (PVCC) power supply. The 3.3-V level is generated
on the board by a voltage regulator from the 5-V supply.
board: a 5-V power supply (VIN) and a 10-V to 26-V (PVCC) power supply. The 3.3-V level is generated
on the board by a voltage regulator from the 5-V supply.
Note:
The power-supply cable length must be minimized. Increasing the length of the PSU cable
increases the distortion of the amplifier at high output levels and low frequencies
increases the distortion of the amplifier at high output levels and low frequencies
The maximum output-stage supply voltage depends on the speaker load resistance. Check the
recommended maximum supply voltage in the TAS5708/10 (
recommended maximum supply voltage in the TAS5708/10 (
) data sheet.
Table 1. Recommended Power Supplies
Description
Voltage Limitations (8-
Ω
Load)
Current Recommendations
System power supply
5 V
1 A
Output power stage supply
10–26 V
4 A
(1)
(1)
The rated current corresponds to two channels, full scale.
SLOU232A – January 2009 – Revised January 2009
TAS5708(TAS5710)EVM
5