Texas Instruments TSC2008EVM-PDK Evaluation Module TSC2008EVM-PDK TSC2008EVM-PDK Datenbogen
Produktcode
TSC2008EVM-PDK
www.ti.com
Kit Operation
Table 6. List of Jumpers
Jumper
Shunt Position
Jumper Description
JMP1
2-3
Analog power select (default is +3.3VD)
JMP2
Closed
EEPROM address select. When installed and used with the USB-MODEVM, firmware for the
motherboard is executed from the EEPROM on the TSC2008EVM. This is the default mode.
motherboard is executed from the EEPROM on the TSC2008EVM. This is the default mode.
6
Kit Operation
The following section provides information on using the TSC2008EVM-PDK, including setup, program
installation, and program usage.
installation, and program usage.
6.1
TSC2008EVM-PDK Block Diagram
A block diagram of the TSC2008EVM-PDK is shown in
. The evaluation kit consists of two circuit
boards connected together. The motherboard is designated as the USB-MODEVM interface board; the
daughtercard is the TSC2008EVM described previously in this manual.
daughtercard is the TSC2008EVM described previously in this manual.
5
SLAU248 – May 2008
TSC2008EVM and TSC2008EVM-PDK User's Guide
Copyright © 2008, Texas Instruments Incorporated