Texas Instruments Multi-Cal-System Basic Starter Kit MULTI-CAL-SYSTEM MULTI-CAL-SYSTEM Datenbogen
Produktcode
MULTI-CAL-SYSTEM
Place jumpers on Slave
in the Slave1a and Slave1b
positions
USB DAQ: Generates
signals and controls
Interface boards:
Sensors connect here
Master and
Slave Mux
DMM and
power supply
Expanding the System Size
shows the jumpers on the Multi-Cal-Slave board that identify the board location. The jumpers on
each slave board must be in a unique position. For the first slave board connected, set the jumpers in the
Slave1a and Slave1b position. As you add additional boards, increment the jumper position. For example,
on the second board connected, use the Slave2a and Slave2b position.
Slave1a and Slave1b position. As you add additional boards, increment the jumper position. For example,
on the second board connected, use the Slave2a and Slave2b position.
Figure 28. Jumper Locations and Positions for Expanding System Size
The final step to expanding the system is to connect the interface-cables from the slave to an interface
board.
board.
shows the complete system connection for a 16-channel system (that is, one master and
one slave).
Figure 29. Complete Expanded System
27
SBOU087A
–
August 2010
–
Revised April 2011
Multi-Cal-System Evaluation Module
Copyright
©
2010
–
2011, Texas Instruments Incorporated