Texas Instruments Multi-Cal-Slave Circuit Board MULTI-CAL-SLAVEKIT MULTI-CAL-SLAVEKIT Datenbogen
Produktcode
MULTI-CAL-SLAVEKIT
Theory of Operation for Multi-Cal-Slave EVM Hardware
www.ti.com
illustrates the jumpers and associated circuitry for selecting the slave (1 through 7). The seven
slave signals are used to clock in data to U35. These data are used to control the multiplexers on the
slave board.
slave board.
Figure 4. Slave Select Jumpers to U35
The signals from U933 are used throughout the Multi-Cal-Slave board to set the I
2
C address on bus
expanders.
shows a typical example of this configuration. Pins 1, 2, and 3 on U800 select the I
2
C
address for this device. The same connections are made on U820, U821, and U921.
Figure 5. I
2
C Address Decoding from U933 to U800
6
Multi-Cal-Slave Evaluation Module
SBOU094 – September 2010
Copyright © 2010, Texas Instruments Incorporated