Texas Instruments 4MHz High-Current LED Driver (Synchronous Boost Converter) Evaluation Module Board LM3565EVM LM3565EVM Datenbogen
Produktcode
LM3565EVM
Setup
Figure 2. VIO Jumper Settings
J5 - LEDs - is the jumper used to connect the on-board flash LEDs to the LED output of the driver.
STROBE - This pin provides an external method for initiating a flash or torch event. The STROBE pin is
connected to ground via a 300 K
connected to ground via a 300 K
Ω
resistor internal to the LM3565. To externally drive this pin, either
connect a control signal directly to the STROBE pin of the connector or place a jumper between connector
pins STROBE and PWM0. Pin PWM0 can be configured as ON, OFF, time-adjustable voltage pulse or
continuous voltage pulses of adjustable frequency and duty cycle via the General User Interface software
provided.
pins STROBE and PWM0. Pin PWM0 can be configured as ON, OFF, time-adjustable voltage pulse or
continuous voltage pulses of adjustable frequency and duty cycle via the General User Interface software
provided.
Figure 3. STROBE Jumper Settings
TORCH - This pin provides an external method for initiating a torch event without having to write the
command through the I
command through the I
2
C-compatible interface. The TORCH pin is connected to ground via a 300 K
Ω
resistor internal to the LM3565. To externally drive this pin, either connect a control signal directly to the
TORCH pin of the connector or place a jumper between connector pins TORCH and PWM1. Pin PWM1
can be configured as ON, OFF, time-adjustable voltage pulse or continuous voltage pulses of adjustable
frequency and duty cycle via the General User Interface software provided.
TORCH pin of the connector or place a jumper between connector pins TORCH and PWM1. Pin PWM1
can be configured as ON, OFF, time-adjustable voltage pulse or continuous voltage pulses of adjustable
frequency and duty cycle via the General User Interface software provided.
Figure 4. TORCH Jumper Settings
TX - This pin is used to initiate a TX-interrupt event. The TX pin is connected to ground via a 300 K
Ω
resistor internal to the LM3565. To externally drive this pin, either connect a control signal directly to the
TX pin of the connector or place a jumper between connector pins TX and PWM2. Pin PWM2 can be
configured as ON, OFF, time-adjustable voltage pulse or continuous voltage pulses of adjustable
frequency and duty cycle via the General User Interface software provided.
TX pin of the connector or place a jumper between connector pins TX and PWM2. Pin PWM2 can be
configured as ON, OFF, time-adjustable voltage pulse or continuous voltage pulses of adjustable
frequency and duty cycle via the General User Interface software provided.
3
SNVU195A – FEBRUARY 2013 – Revised MAY 2013
LM3565EVM User's Guide
Copyright © 2013, Texas Instruments Incorporated