Texas Instruments BQ27545EVM Single Cell, Pack Side, Impedance Track Fuel Gauge Evaluation Module BQ27545EVM BQ27545EVM Datenbogen
Produktcode
BQ27545EVM
Troubleshooting Unexpected Dialog Boxes
5. Before starting the EVSW, connect the EV2400 to the computer using the USB cable.
6. Wait for 20 seconds or until windows installs the driver.
6
Troubleshooting Unexpected Dialog Boxes
The user that is downloading the files must be logged in as the administrator. The driver is not signed, so
the administrator must allow installation of unsigned drivers in the operating system policy.
the administrator must allow installation of unsigned drivers in the operating system policy.
7
Hardware Connection
The bq27545EVM comprises three hardware components: the bq27545 circuit module, the
EV2300/EV2400 PC interface board, and the PC.
EV2300/EV2400 PC interface board, and the PC.
7.1
Connecting the bq27545 Circuit Module to a Battery Cell
shows how to connect the bq27545 circuit module to the cell and system load or charger.
Figure 8. bq27545 Circuit Module Connection to Cell and System Load or Charger
7.2
PC Interface Connection
The bq27545 can be configured as an HDQ communication device or left in default as an I
2
C device.
Once the bq27545 is configured for HDQ communication, it cannot be reverted to I
2
C mode. Refer to
chapter 12 of this document for information on configuring the bq27545 to HDQ mode.
The following steps configure the hardware for interfacing to the PC:
1. Connect the bq27545-based pack to the EV2300/EV2400 using wire leads as shown in
.
10
bq27545EVM Single-Cell Impedance Track™ Technology Evaluation Module
SLUU984 – September 2012
Copyright © 2012, Texas Instruments Incorporated