Texas Instruments TAS5717EVM Evaluation Module TAS5717EVM TAS5717EVM Datenbogen

Produktcode

TAS5717EVM

Jumpers and Control Utilities on MC57xxPSIA board

www.ti.com

3.6.1.1

2 X BTL BD (BD mode)

1. Set up the hardware.
2. Select the Input MUX from GDE. In the Properties window, select BD Mode.
3. GDE: Target > Connect.
4. Finally uncheck the shutdown box to bring the device out of Shutdown mode, and adjust the Master

Volume as desired.

3.6.1.2

2 X BTL AD (Default: AD mode)

1. Set up the hardware.
2. Select the Input MUX from GDE. In the Properties window, select AD Mode.
3. GDE: Target > Connect.
4. Finally uncheck the shutdown box to bring the device out of Shutdown mode, and adjust the Master

Volume as desired.

Jumpers and Control Utilities on MC57xxPSIA board

4.1

RCA/OPTICAL Jumpers

Select the jumper to reflect the source whether it is RCA or OPTICAL.

4.2

Switches

JP1 on the daughter card is for PBTL select. Jumper IN means non-PBTL mode. For PBTL, remove this
jumper.

Reset is an active-low function. Pressing the master reset switch (S2) resets the TAS5717/19 device; USB
RESET (S1) resets the USB bus. Pressing PDNZ (S4) powers down the TAS5717/19, and pressing
MUTE (S5) mutes (volume mute) the TAS5717/19.

4.3

LED Indicators

LED1 : USB Power connector installed at J1

LED2 : 3.3V Power is valid

LED3: RCA connection made

LED4: Optical connection made

LED5: SPDIF signal locked

LED6: FAULT (This LED should be ignored until FAULT is programmed to be an output via I

C write

to reg 0X05.)

LED7: PDN switch (S4) is pressed (closed)

TAS5717/19 10W/15W Digital Audio Power Amplifier with Integrated

SLOU303 – November 2010

Capacitor-Free HP Amplifier

Submit Documentation Feedback