Texas Instruments SN65LVDS4 Evaluation Module SN65LVDS4EVM SN65LVDS4EVM Datenbogen
Produktcode
SN65LVDS4EVM
Introduction
1
Introduction
The Texas Instruments SN65LVDS4 Evaluation Module (EVM) board is used to evaluate the SN65LVDS4
LVDS receiver. The device can provide output voltage logic levels based on an external VDD pin, thus
eliminating the need for external level translation. The board enables the system designer to connect 50-
LVDS receiver. The device can provide output voltage logic levels based on an external VDD pin, thus
eliminating the need for external level translation. The board enables the system designer to connect 50-
Ω
coaxial cables via SMA connectors at the inputs and an SMA or high-impedance probe at the output.
WARNING
This equipment is intended for use in a laboratory test environment
only. It generates, uses, and can radiate radio frequency energy
and has not been tested for compliance with the limits of
computing devices pursuant to subpart J of part 15 of FCC rules,
which are designed to provide reasonable protection against radio
frequency interference. Operation of this equipment in other
environments may cause interference with radio communications,
in which case, users at their own expense will be required to take
whatever measures may be required to correct this interference.
only. It generates, uses, and can radiate radio frequency energy
and has not been tested for compliance with the limits of
computing devices pursuant to subpart J of part 15 of FCC rules,
which are designed to provide reasonable protection against radio
frequency interference. Operation of this equipment in other
environments may cause interference with radio communications,
in which case, users at their own expense will be required to take
whatever measures may be required to correct this interference.
2
SN65LVDS4EVM Kit Contents
The SN65LVDS4EVM kit contains the following:
•
SN65LVDS4EVM board
•
SN65LVDS4EVM User
’
s Guide (this document)
3
SN65LVDS4EVM Board Configuration
The SN65LVDS4 input differential pair (J1, J3) and single-ended output (J2) are available through the
edge launch SMA connectors.
edge launch SMA connectors.
Figure 1. SN65LVDS4EVM Board
2
SN65LVDS4 Evaluation Module
SLLU151
–
July 2011
Copyright
©
2011, Texas Instruments Incorporated