Texas Instruments BUF12800 Evaluation Module BUF12800EVM BUF12800EVM Datenbogen
Produktcode
BUF12800EVM
BUF12800EVM Software Overview
shows an error that pops up if the computer cannot communicate with the EVM. If you receive
this error, first ensure that the USB cable is properly connected on both ends. This error can also occur if
you connect the USB cable before the USB DIG Platform power source. Another possible cause for this
error is a problem with the USB Human Interface Device Driver on the computer you are using. Make sure
that the device is recognized when the USB cable is plugged in; this action is indicated by a
Windows-generated confirmation sound.
you connect the USB cable before the USB DIG Platform power source. Another possible cause for this
error is a problem with the USB Human Interface Device Driver on the computer you are using. Make sure
that the device is recognized when the USB cable is plugged in; this action is indicated by a
Windows-generated confirmation sound.
Figure 15. Communication Error with USB DIG Platform
6.2
Using the BUF12800 Software
6.2.1
I
2
C Address Selection
As mentioned previously (refer to
), jumper JMP6 is used to set the I
2
C address pin of the
BUF12800.
shows how the hardware and software must both be set to enable communication
between the BUF12800EVM and the software. Without jumper JMP6 and the software address button
configured correctly, the software cannot communicate with the BUF12800 device.
configured correctly, the software cannot communicate with the BUF12800 device.
Figure 16. JMP6 Setting for Logic
‘
0
’
17
SBOU116
–
September 2011
BUF12800EVM Evaluation Board and Software Tutorial
Copyright
©
2011, Texas Instruments Incorporated