Texas Instruments EZ430-CHRONOS-868 Benutzerhandbuch
Chapter 2
SLAU292D – November 2009 – Revised March 2011
Getting Started
2.1
Using the eZ430-Chronos Watch Stand Alone
For first time use, remove the eZ430-Chronos watch from box and press any button twice to wake the
watch from sleep mode (after the first button press, the LCD displays the same content as shown on the
box of the kit; after the second button press, the watch starts full operation).
watch from sleep mode (after the first button press, the LCD displays the same content as shown on the
box of the kit; after the second button press, the watch starts full operation).
NOTE:
For the next steps it is important to understand the eZ430-Chronos user concept. The top
and bottom LCD lines can be controlled individually by pushing the buttons on the left side.
The buttons on the right side are used to select or activate secondary functions. Detailed
instructions are available in
The buttons on the right side are used to select or activate secondary functions. Detailed
instructions are available in
.
Figure 2-2. Overview eZ430-Chronos LCD
Figure 2-1. eZ430-Chronos Watch Push Buttons
2.1.1 Setting the Time
1. Push the "*" button until the time is displayed in the top LCD line.
2. Hold "*" for three seconds until the time disappears and "12H" or "24H" is shown on the LCD.
3. Select 12H/24H modes by pushing the "UP" or "DOWN" buttons.
4. Press "#" to continue with the time adjustment.
5. Set the hours by pushing the "UP" or "DOWN" button.
6. Press "#" to continue with the minute adjustment.
7. Set the minutes by pushing the "UP" or "DOWN" button.
8. Press "#" to continue with the second adjustment.
9. Set the seconds by pushing the "UP" or "DOWN" button.
10. Press "*" to confirm the settings and go back to normal operation, or press "#" to start over with step 2.
2. Hold "*" for three seconds until the time disappears and "12H" or "24H" is shown on the LCD.
3. Select 12H/24H modes by pushing the "UP" or "DOWN" buttons.
4. Press "#" to continue with the time adjustment.
5. Set the hours by pushing the "UP" or "DOWN" button.
6. Press "#" to continue with the minute adjustment.
7. Set the minutes by pushing the "UP" or "DOWN" button.
8. Press "#" to continue with the second adjustment.
9. Set the seconds by pushing the "UP" or "DOWN" button.
10. Press "*" to confirm the settings and go back to normal operation, or press "#" to start over with step 2.
13
SLAU292D – November 2009 – Revised March 2011
Getting Started
© 2009–2011, Texas Instruments Incorporated