Texas Instruments MSP430FG4618/F2013 Experimenter Board MSP-EXP430FG4618 MSP-EXP430FG4618 Datenbogen
Produktcode
MSP-EXP430FG4618
10
Appendix A Configuring an IAR Embedded Workbench Project
IAR Embedded Workbench may be used to program/debug the on-board MSP430
devices with custom firmware or provided sample code available at
www.ti.com/msp430
. Programming and debug is done using JTAG1 and JTAG2
providing access to the MSP430FG4618 and MSP430F2013 respectively. Steps
to program each of these devices are shown in this section. It is assumed that the
USB FET tool has been installed using the instructions provided in the FET User’s
guide. Please note that the Parallel port FET tool can also be used to
program/debug the MSP430FG4618.
MSP430FG4618 Programming
1. Connect the 14-pin cable to the JTAG1 header on the board.
2. Create a new project or load a valid existing project on the IAR Embedded
Workbench.
3. In IAR Embedded Workbench under the Project drop-down choose Options;
this brings up the menu shown in Figure A-1. Under the General
Options
Options
ÆTarget
choose MSP430FG4618 from the MSP430x4xx Family
option.
Figure A-1: Device selection in IAR