Texas Instruments MSP-TS430PM64A - MSP430 64-Pin Target board MSP-TS430PM64A MSP-TS430PM64A Datenbogen
Produktcode
MSP-TS430PM64A
Hardware Installation
C.1
Hardware Installation
shows the USB VIDs and PIDs used in MSP430 tools.
Table C-1. USB VIDs and PIDs Used in MSP430 Tools
Tool
USB VID
USB PID
INF File Name
eZ430-F2013
0x0451
0xF430
usbuart3410.inf
eZ430-RF2500
0x0451
0xF432
430CDC.inf
eZ430-RF2780
0x0451
0xF432
430CDC.inf
eZ430-RF2560
0x0451
0xF432
430CDC.inf
MSP-WDSxx "Metawatch"
0x0451
0xF432
430CDC.inf
eZ430-Chronos
0x0451
0xF432
430CDC.inf
MSP-FET430UIF
(1)
0x2047
0x0010
msp430tools.inf
LaunchPad (MSP-EXP430G2)
0x0451
0xF432
430CDC.inf
MSP-EXP430FR5739
0x0451
0xF432
430CDC.inf
MSP-EXP430F5529
0x0451
0xF432
430CDC.inf
(1)
The older MSP-FET430UIF used with IAR versions before v5.20.x and CCS versions before v5.1 has VID 0x0451 and PID
0xF430. With the firmware update, it is updated to the 0x2047 and 0x0010, respectively.
0xF430. With the firmware update, it is updated to the 0x2047 and 0x0010, respectively.
1. Before connecting of the USB Debug Interface with a USB cable to a USB port of the PC the one of
IDEs (CCS or IAR) should be installed. The IDE installation isntalls also drivers for USB Debug
Interfaces without user interaction. After IDE installation the USB Debug Interface can be connected
and will be ready to work within few seconds.
Interfaces without user interaction. After IDE installation the USB Debug Interface can be connected
and will be ready to work within few seconds.
2. The driver can be also installed manually. After plug in the USB Debug Interface to USB port of the PC
the Hardware Wizard starts automatically and opens the "Found New Hardware Wizard" window.
3. Select "Install from a list or specific location (Advanced)" (see
Figure C-1. Windows XP Hardware Wizard
146
Hardware Installation Guide
SLAU278Q – May 2009 – Revised February 2014
Copyright © 2009–2014, Texas Instruments Incorporated