Insys GSM EASY 4.1 11-02-01-03-01.027 Benutzerhandbuch
Produktcode
11-02-01-03-01.027
Initial Operation
INSYS GSM 4.2 easy
22
January 07
4.2
Initial Operation
The easiest way to perform the initial operation is to use the configuration
software HSComm GSM easy in Windows.
Carry out the following steps:
1. Have the SIM card and PIN number ready, but do not insert the card yet.
software HSComm GSM easy in Windows.
Carry out the following steps:
1. Have the SIM card and PIN number ready, but do not insert the card yet.
2. Connect the INSYS GSM 4.2 easy and the PC with a serial cable (male/female).
Connect the GSM antenna.
3. Connect the power supply to the terminals 10 … 60 VDC and the minus pole to
GND. Switch the device on.
4. Initialization starts:
¾
¾
LED Connect is on for approx. 4 seconds
¾
After 8 more seconds the LED Status starts to flash for approx. 20 seconds
¾
Afterwards, the LED Status goes out because no SIM card is inserted and no
PIN is stored.
¾
The LED Signal is on or blinks depending on the strength of the GSM network.
5. Start HSComm for INSYS GSM 4.2 easy in Windows.
The program opens.