Insys GSM Small 11-02-01-03-02.001 Benutzerhandbuch
Produktcode
11-02-01-03-02.001
3. Technical Data
5
LED Color
On
Blinking
Flashing
Off
green
Only with setting
AT&C1 (default):
Connection setup:
Remote terminal has
answered; connection
handshake is taking
place
AT&C1 (default):
Connection setup:
Remote terminal has
answered; connection
handshake is taking
place
With setting AT&C1
(default):
Timing: 600 ms on /
600 ms off
(default):
Timing: 600 ms on /
600 ms off
The device has not
been registered in the
GSM network (e.g.
network loss, no SIM
card inserted or no PIN
entered).
been registered in the
GSM network (e.g.
network loss, no SIM
card inserted or no PIN
entered).
With setting
AT&C1
(default):
Timing 75 ms
on / 3 s off
Device has
been registered
in the GSM
network
AT&C1
(default):
Timing 75 ms
on / 3 s off
Device has
been registered
in the GSM
network
orange
When the LED Power
Rx/Tx is also orange:
Device is in power
down mode,
otherwise:
AT&C1 as well as
ATC0:
Data connection has
been established and
DCD is active
In addition for setting
AT&C0;
Connection setup:
Remote terminal has
answered; connection
handshake is taking
place
Rx/Tx is also orange:
Device is in power
down mode,
otherwise:
AT&C1 as well as
ATC0:
Data connection has
been established and
DCD is active
In addition for setting
AT&C0;
Connection setup:
Remote terminal has
answered; connection
handshake is taking
place
GSM
network
- DCD
network
- DCD
red
- - -
Only for setting
AT&C0:
Timing 600 ms orange
/ 600 ms red
The device has not
been registered in the
GSM network (e.g.
network loss, no SIM
card inserted or no PIN
entered).
AT&C0:
Timing 600 ms orange
/ 600 ms red
The device has not
been registered in the
GSM network (e.g.
network loss, no SIM
card inserted or no PIN
entered).
Only for setting
AT&C0:
Timing 75 ms
orange / 3 s red
Device has
been registered
in the GSM
network
AT&C0:
Timing 75 ms
orange / 3 s red
Device has
been registered
in the GSM
network
No operating
voltage
applied
voltage
applied
3.2.2 Terminal Layout
The terminals are located on the upper side of the housing
Attention:
The value for Pin 1 stated on the cover top is a maximum value.
1
24V DC
Power supply 12V -24V DC
2 GND
Ground
3 RESET
Reset
input
Version 1.00 / 09.04