Insys GSM Small 11-02-01-03-02.001 Benutzerhandbuch
Produktcode
11-02-01-03-02.001
40
7. Command Overview
To ease readability of the further comments, <CR> is always used as carriage return
character. The standard responses are always OK or ERROR , regardless of the actually
selected responses according to V.25.
After the response to a command, a waiting period of at least 100 ms is recommended
before the next command to enable the sending of more non-synchronous event codes,
if necessary.
For lining up standard AT commands please refer to the detailed command set of the
GSM engine.
character. The standard responses are always OK or ERROR , regardless of the actually
selected responses according to V.25.
After the response to a command, a waiting period of at least 100 ms is recommended
before the next command to enable the sending of more non-synchronous event codes,
if necessary.
For lining up standard AT commands please refer to the detailed command set of the
GSM engine.
7.2 Short Description AT commands
The AT commands comprise the specification according to V.25ter, GSM 07.07 and GSM
07.05. Only the most important AT commands with syntax and parameters are described
in the following. A complete command reference of the Siemens TC35i is available from
INSYS MICRO-ELECTRONICS (e-mail: insys@insys-tec.de).
The applicability of single features may depend on the functionality of the selected GSM
network.
Syntax:
07.05. Only the most important AT commands with syntax and parameters are described
in the following. A complete command reference of the Siemens TC35i is available from
INSYS MICRO-ELECTRONICS (e-mail: insys@insys-tec.de).
The applicability of single features may depend on the functionality of the selected GSM
network.
Syntax:
<expressions>
in angular brackets stand for parameters.
[expressions]
in square brackets stand for optional entries.
Default settings are set off in bold.
7.2.1 AT Commands According To V.25ter
+++
Change from data mode to command mode (online command mode). 1 second
pause before and after the entry, no <CR>.
pause before and after the entry, no <CR>.
ATA
Call acceptance (see also ATS0 for automatic call acceptance)
ATD[<n>]
Dialing the phone number <n>.
ATDL
Last number re-dialing
ATE<n>
Set command echo:
<n>
0
Off
1 on
ATH
Terminate existing connection
ATI
Output of product information of the GSM engine
ATO
Switch back from command mode to data mode
Version 1.00 / 09.04