Analog Devices SDP Breakout Board ADZS-BRKOUT-EX3 ADZS-BRKOUT-EX3 Datenbogen
Produktcode
ADZS-BRKOUT-EX3
AD2S1200/AD2S1205 User Guide
UG-365
Rev. D | Page 7 of 24
BASIC HARDWARE SETUP
board connects to the
board is the controller board, which is the
communication link between the PC and the main evaluation
board. Figure 2 shows a photograph of the connections made
between the
board. Figure 2 shows a photograph of the connections made
between the
board.
A resolver or resolver simulator should be connected to the
board as outlined in Table 6. The
primary windings, R1 and R2, are connected to the buffered
excitation ouputs from the evaluation board. The resolver
stator outputs should be connected to the corresponding
excitation ouputs from the evaluation board. The resolver
stator outputs should be connected to the corresponding
board inputs.
Table 6. Typical Resolver Connection
Resolver
Name
Pin
Connector
R1
EXE
2
J6
R2
EXE
1
S1
SIN
4
J5
S2
COS
1
S3
SINLO
3
S4
COSLO
2
The gain stage for the excitation buffer can be controlled via
Link LK7 and Link LK8. These should be configured to provide
the necessary gain to allow the resolver inputs to lie within the
required specification. See Table 2 for the link options.
Before connecting power, connect the
Link LK7 and Link LK8. These should be configured to provide
the necessary gain to allow the resolver inputs to lie within the
required specification. See Table 2 for the link options.
Before connecting power, connect the
board to Connector A on the
board. Nylon
kit and can
and
boards are connected firmly together.
After the
board and the
board. The
board requires an external power supply adapter, which is
included in the evaluation board kit. Connect this power supply
to Connector J702 on the
included in the evaluation board kit. Connect this power supply
to Connector J702 on the
board. For
further details on the required power supply connections and
options, see the Power Supplies section.
Before connecting the
options, see the Power Supplies section.
Before connecting the
board to your PC,
ensure that the
software has been
installed from the enclosed CD. The full software installation
procedure is detailed in the Evaluation Board Software section.
Finally, connect the
procedure is detailed in the Evaluation Board Software section.
Finally, connect the
board to the PC via the
USB cable enclosed in the
kit. If using a
Windows XP platform, you may need to search for the
drivers. Choose to automatically search for the
drivers for the
board if prompted by the
operating system.