Analog Devices AD8045 Evaluation Board AD8045ARD-EBZ AD8045ARD-EBZ Datenbogen
Produktcode
AD8045ARD-EBZ
Evaluation Board User Guide
UG-084
Rev. B | Page 5 of 8
NONINVERTING CONFIGURATION
When using this board in a noninverting configuration, with a
gain larger than 1, there are two recommended ways to place the
gain resistor. The first way is to place the gain resister in the R1
location and uses a 0 Ω for the R2 location to short to ground.
The second way is to place the gain resister between the first pad
of R1 and ground, without using a second resistor (see Figure 8).
gain larger than 1, there are two recommended ways to place the
gain resistor. The first way is to place the gain resister in the R1
location and uses a 0 Ω for the R2 location to short to ground.
The second way is to place the gain resister between the first pad
of R1 and ground, without using a second resistor (see Figure 8).
08787-
008
Figure 8. Noninverting Configuration with a Gain of Higher Then 1