Mikroelektronika MikroE Development Kits MIKROE-1436 Datenbogen
Produktcode
MIKROE-1436
1. Introduction
Once you have soldered the headers your
board is ready to be placed into desired
mikroBUS
board is ready to be placed into desired
mikroBUS
™
socket. Make sure to align the
cut in the lower-right part of the board
with the markings on the silkscreen at
the mikroBUS
with the markings on the silkscreen at
the mikroBUS
™
socket. If all of the pins are
aligned correctly, push the board all
the way into the socket.
3. Plugging the board in
2
3
2. Soldering the headers
1
4. Essential features
Turn the board upward again. Make sure
to align the headers so that they are
perpendicular to the board, then solder the
pins carefully.
to align the headers so that they are
perpendicular to the board, then solder the
pins carefully.
Turn the board upside down so that
bottom side is facing you upwards.
Place shorter pins of the header into the
appropriate soldering pads.
bottom side is facing you upwards.
Place shorter pins of the header into the
appropriate soldering pads.
Before using your click
™
board, make sure
to solder 1x8 male headers to both left
and right side of the board. Two 1x8 male
headers are included with the board in
the package.
and right side of the board. Two 1x8 male
headers are included with the board in
the package.
click
BOARD
www.mikroe.com
Fiber Opt click 3.3V Manual
ver. 1.01
0 100000 023938
Fiber Opt click
™
is an accessory board in
mikroBUS
™
form factor. It’s a compact
and easy solution for adding fiber-optic
communication to your design. It features
communication to your design. It features
IF-D91
fiber-optic photodiode,
IF-E97
fiber-
optic LED diode as well as two operational
amplifiers. Fiber Opt click
amplifiers. Fiber Opt click
™
communicates
with the target board microcontroller via
mikroBUS
™
UART (TX, RX), INT and PWM
lines. The board is designed to use 3.3V
power supply only. LED diode (GREEN)
indicates the presence of power supply.
power supply only. LED diode (GREEN)
indicates the presence of power supply.
Fiber Opt click
™
with it’s
IF-D91
and
IF-E97
results in support for fiber-optic
communication. Each of the plastic optic
connector features an internal micro-lens and
a precision-molded PBT housing to ensure
efficient optical coupling with plastic fiber
cable. The board can achieve data rates up
to 512 Kbps. These features make this board
ideal for data links, local area networks, motor
controller triggering, medical instruments,
EMC/EMI signal isolation and many more.
connector features an internal micro-lens and
a precision-molded PBT housing to ensure
efficient optical coupling with plastic fiber
cable. The board can achieve data rates up
to 512 Kbps. These features make this board
ideal for data links, local area networks, motor
controller triggering, medical instruments,
EMC/EMI signal isolation and many more.
3.3V
Fiber Opt
click