Mikroelektronika MikroE Development Kits MIKROE-1199 Datenbogen
Produktcode
MIKROE-1199
1. Introduction
Once you have soldered the headers your
board is ready to be placed into desired
mikroBUS™ socket. Make sure to align the
cut in the lower-right part of the board
with the markings on the silkscreen at the
mikroBUS™ socket. If all of the pins are
board is ready to be placed into desired
mikroBUS™ socket. Make sure to align the
cut in the lower-right part of the board
with the markings on the silkscreen at the
mikroBUS™ socket. If all of the pins are
aligned correctly, push the board all
the way into the socket.
3. Plugging the board in
2
3
2. Soldering the headers
1
4. Essential features
Turn the board upward again. Make sure
to align the headers so that they are
perpendicular to the board, then solder the
pins carefully.
to align the headers so that they are
perpendicular to the board, then solder the
pins carefully.
Turn the board upside down so that
bottom side is facing you upwards. Place
shorter parts of the header pins in both
soldering pad locations.
bottom side is facing you upwards. Place
shorter parts of the header pins in both
soldering pad locations.
Flash
click
Before using your click board™, make sure
to solder 1x8 male headers to both left
and right side of the board. Two 1x8 male
headers are included with the board in
the package.
to solder 1x8 male headers to both left
and right side of the board. Two 1x8 male
headers are included with the board in
the package.
click
BOARD
www.mikroe.com
Flash click Manual
ver. 1.00
0 100000 021057
Flash Click™ is an accessory board in
mikroBUS
™
form factor. It’s a compact and
easy solution for adding more flash memory
to your device. It features
to your device. It features
M25P80 - 8Mb
serial Flash memory module with advanced
hardware write protection mechanisms.
hardware write protection mechanisms.
Flash Click™
communicates with the
target board via SPI interface
.
The board is
designed to use 3.3V power supply only
.
It
has a LED diode (GREEN) that indicates the
presence of power supply.
presence of power supply.
Flash Click™ with it’s
M25P80
module
gives additional
8Mb of
Flash memory to
your design.
The
M25P80
supports high-
performance commands for clock frequency
up to 75MHz. It is divided in 16 sectors, each
containing 256 pages. Each page is 256 bytes
wide. Memory can be viewed either as 4,096
pages or as 1,048,576 bytes.
up to 75MHz. It is divided in 16 sectors, each
containing 256 pages. Each page is 256 bytes
wide. Memory can be viewed either as 4,096
pages or as 1,048,576 bytes.