Mikroelektronika MikroE Development Kits MIKROE-573 Datenbogen

MikroElektronika

Figure 1: EasyLED additional board

The EasyLED additional board can be easily connected to a development system via an IDC10 connector CN2. The 

CN1 connector is used to access the port pins the additional board is connected to. 

The EasyLED board is used to show the logic level on the development system ports. When a pin is driven high (logic 

1), the appropriate LED connected to that pin is turned on. Likewise, if a pin is driven low (logic 0), the appropriate LED  

will not illuminate. 

The EasyLED additional board is used to connect a development system port to LEDs.

 

- Parallel communication;

 

- 8 LEDs;

 

- 3.3V or 5V power supply voltage.

Figure 2: Dimensions of the EasyLED board

: When the EasyLED board features red LEDs, the value of the RN1 resistor is 4K7.