Mikroelektronika MikroE Development Kits MIKROE-1298 Datenbogen

1. Introduction

Once you have soldered the headers your 
board is ready to be placed into desired 
mikroBUS™ socket. Make sure to align the 
cut in the lower-right part of the board 
with the markings on the silkscreen at the 
mikroBUS™ socket. If all of the pins are 

aligned correctly, push the board all 

the way into the socket.

3. Plugging the board in

2

3

2. Soldering the headers

1

4. Essential features

Turn the board upward again. Make sure 
to align the headers so that they are 
perpendicular to the board, then solder the 
pins carefully.

Turn the board upside down so that 
bottom side is facing you upwards. Place 
shorter parts of the header pins in both 
soldering pad locations.

Before using your click board™, make sure 
to solder 1x8 male headers to both left 
and right side of the board. Two 1x8 male 
headers are included with the board in 
the package.

click

BOARD

www.mikroe.com

GSM click Manual

0 100000 025246

GSM click

™

 is an add-on board in 

™

 

form factor. It’s a compact and easy solution 
for adding GSM/GPRS mobile phones 
standard to your design. It features 

 GSM/GPRS module, 

 6-bit 

bidirectional voltage-level translator as well 
as SIM CARD socket. GSM click

™

 communicates 

with target board microcontroller via seven 

™

 lines (RX, TX, INT, PWM, CS, RST 

and AN). The board is designed to use 3.3V 
and 5V I/O voltage level.

 

LED diode indicates 

the presence of power supply.

GSM 

click

GSM click™ with it’s Telit GL865-QUAD IC is 
ideal for mobile devices. It features GSM/GPRS 
protocol stack 3GPP (release 4 compliant) 

 

and supports GSM/GPRS 850/900/1800/ 
1900 MHz Quad-band frequency. Additional 
features such as integrated TCP/IP protocol 
stack (including UDP, SMTP, ICMP and FTP), 
serial multiplexer, remote AT commands and 
many more, extend the functionality of the 
board.