Reely RtF 630 mm 1232130 Benutzerhandbuch

To ensure that 2.4 GHz remote controls can transfer their signal without interference, the transmitter and receiver must 

have the same digital code. Alignment of the digital encoding (binding between transmitter and receiver) is performed 

with the binding function. 
Transmitter and receiver are usually already aligned with each other or bound in the factory and can be used at 

once. 
Binding only needs to be performed again after replacing the transmitter or receiver or to remove malfunctions.
Since different manufacturers use different encoding methods, transmitter and receiver cannot be combined and 

operated with products of other manufacturers.
Re-establishing the binding:
•  Push onto the left control lever (push it like a regular 

button) from the top with the transmitter switched off 

and hold it in this position.

•  Switch on the transmitter with the control lever pushed 

(2) and then release the control lever (1) again. 

  The transmitter switches to binding mode and issues a 

signal sound at a rhythm of seconds for 20 seconds. 

  The function control display at the transmitter flashes 

at the same time.

•  Connect the flight battery (3) to the model during the 

binding phase of 20 seconds. 

  During the binding process, the LED in the model lights 

up and the electronics issues double signal sounds at 

regular intervals. 

•  After the end of the 20 seconds, the binding phase is 

completed and the transmitter and model enter regular 

operating conditions. 

•  Finally,  check  correct  function  of  the  remote  control 

system and the model.