Reely ARF 1095 mm 208918 Datenbogen
Produktcode
208918
40
In this critical flying phase, ensure sufficient flying speed and do not slow down the model reducing the motor speed
too much or by pulling too hard at the elevator.
too much or by pulling too hard at the elevator.
Slightly move the elevator briefly before touchdown.
After landing, adjust the linkage – if necessary – so that the plane flies straight and the trim levers on the transmitter
are in centre position again. Once you are able to control the airplane perfectly, you can try to optimise flight performance
by shifting the centre of gravity.
are in centre position again. Once you are able to control the airplane perfectly, you can try to optimise flight performance
by shifting the centre of gravity.
11. Maintenance and Care
Regularly check the rudder linkages and the control functions of the servos on your model. All moving parts have to be
easily movable but there should not be a clearance in the bearing.
easily movable but there should not be a clearance in the bearing.
The outside of the model should only be cleaned with a soft, moistened cloth. Never use aggressive cleansing agents
or chemical solvents, since this might damage the surfaces.
or chemical solvents, since this might damage the surfaces.
Important!
If you have to replace any damaged or worn parts, only use original replacement parts.
The spare parts list is located on our website www.conrad.com in the download section to the respective product.
You can also order the replacement parts list by phone. For contact information, please refer to chapter „Introduction“
at the beginning of these operating instructions.
at the beginning of these operating instructions.