Reely RtF 322 mm 1086655 Benutzerhandbuch
Produktcode
1086655
44
b) Neutral Position
When the control lever for the rudder and elevator function and the digital trimming of the control functions precisely
in the centre position, the rudder (1) and elevator (2) should be precisely at the centre as well.
Viewed from the rear, the rudders and elevators must form a level with the rudder and must not be deflected to the
Viewed from the rear, the rudders and elevators must form a level with the rudder and must not be deflected to the
top or bottom, left or right.
If the rudder and elevator are not aligned precisely, this can be corrected with the trim function.
If the rudder and elevator are not aligned precisely, this can be corrected with the trim function.
Figure 10
c) Elevator Function
If the control stick for the elevator function (see figure 11) is moved down (to the rear), the elevator must deflect to
the top. The rear rudder edge must be deflected upwards by approx. 2 - 3 mm. In flight, the landing gear is pressed
downwards and the model ascends.
Figure 11
If the control stick for the elevator function (see figure 12) is moved upwards (to the front), the elevator must deflect
down. The rear rudder edge must be deflected downwards by approx. 2 - 3 mm. In flight, the landing gear is pressed
upwards and the model dives. This control function is required to put the model into a normal light position if it wants
to ascend too much due to a control error or a gust of wind.
Figure 12