Reely 4WD RtR 2.4 GHz E16RTBL Datenbogen

If the vehicle does not stop calmly in the neutral position of the throttle/brake lever, you can correct the trimming for 

the driving function at the transmitter.
If the trim path is not sufficient (or if the trim is already almost at the end of the trim path) you can reprogram the neutral

position and the full throttle positions for forward/reverse driving. 
Proceed as follows:
•  Switch on the transmitter, but leave the throttle/brake in the neutral position. Put the trimming for driving into the

centre position. Switch off the speed controller („OFF“).

•  Keep the setup button (2) pressed and turn the speed

controller on („ON“).

•  An  LED  flashes  at  the  speed  controller  then  flashes

red; the motor emits bleeps. Release the setup button 

again.

  If you do not release the setup button, the programming 

mode  is  activated  after  a  few  seconds.  In  this  case, 

switch  off  the  speed  controller  and  proceed  again  as 

described above.

•  Leave the throttle/brake lever in its neutral position and

do not move it!

•  Shortly push the setup button (2). The LED at the speed controller flashes green once and a beep is emitted by the

motor. The neutral position is now saved.

  The beeps are generated by a short start-up of the brushless motor. These beeps may be very low, depen-

ding on the motor. In this case, observe the LED on the speed controller.

•  Move the throttle/brake lever to full throttle for forwards driving, pull it towards the handle and hold it there.

  Attention!

 

If you do not move the transmitter throttle/brake lever during the programming process or do not move it 

far enough, the vehicle might respond to even slight movements of the transmitter throttle lever or become 

uncontrollable. In that case, repeat programming.

•  Shortly push the setup button (2). The LED at the speed controller flashes green twice and two beeps are emitted.

The full throttle position for forward driving is stored.

•  Move the throttle/brake lever to full throttle for reverse driving, push it away from the handle to the stop.
•  Push the setup button (2) briefly. The LED at the speed controller flashes green thrice and three beeps are emitted.

The full throttle position for reverse driving is stored.

•  Release the throttle/brake so that it sits in the neutral position.
•  Now wait for at least 3 seconds. The programming mode is left automatically and the speed controller is ready for

operation with the new settings made.



Æ