Reely 1:10 RC model car Electric Monster truck FS-53801-6 Benutzerhandbuch

These components are not included in delivery. The receiver is delivered with your remote control. The
speed controller has to be ordered separately.

The receiver is attached using double-sided adhesive tape from the bottom of the receiver holder "EH1". In addition,
secure it with a cable tie which is inserted through the holes in the receiver holder. As a result, the receiver cannot
come lose.

The speed controller is attached to the top of the chassis bridge "CB1" using double-sided adhesive tape. The switch
of the speed controller can also be secured using double-sided adhesive tape, e.g. on the steering servo.

Install the aerial cable of the receiver through the holder "AN1" and the aerial tube. Put the aerial tube into the holder
"AN1". Use a rubber cap to secure the aerial cable at the upper end of the aerial tube.

When installing the aerial cable, make sure that it does not touch the cardan shaft or other moving parts. Never
shorten the aerial cable!

Connect the steering servo and the speed controller to the receiver. Observe the operating instructions of the remote
control to learn where to connect the steering servo and the speed controller.

Install the cables so that they cannot get caught in the drive mechanism. Secure the cables with cable ties.