Siemens SPS starter kit 6ED1057-3BA00-0AA8 12 Vdc, 24 Vdc 6ED1057-3BA00-0AA8 Datenbogen
Produktcode
6ED1057-3BA00-0AA8
Tutorial
3.4 Getting started with project creation
LOGO!Soft Comfort Online Help
166
Operating Instructions, 06/2014
3.4.3.6
Configuring Ethernet connection, LOGO! to non-project devices
LOGO!Soft Comfort supports the creation and configuration of Ethernet connections
between LOGO! Base Modules and devices outside of the current project.
You can right-click the LOGO! Base Module or its connector and choose to add a server
You can right-click the LOGO! Base Module or its connector and choose to add a server
connection or a client connection.
Adding server connection
Follow the steps below to configure the server connection.
①
LOGO! Base Module:
Here you can set if you are trying to connect to an operator panel like SIMATIC Panel.
Here you can set if you are trying to connect to an operator panel like SIMATIC Panel.
②
Non-project Device:
Here you can set whether to allow access from all requests, or enter the IP address and TSAP
Here you can set whether to allow access from all requests, or enter the IP address and TSAP
port to enable connection to the non-project device.
You must allow access from all requests if you are trying to connect to devices outside of the
You must allow access from all requests if you are trying to connect to devices outside of the
LAN (Local Area Network).
③
Data transfer table
Use the check box to activate the data transfer table.
See Tools -> Ethernet Connections (0BA7 and 0BA8 only) (Page 100) for more information
Use the check box to activate the data transfer table.
See Tools -> Ethernet Connections (0BA7 and 0BA8 only) (Page 100) for more information
about data transfer configurations.