Wago 750-333 PROFIBUS DP/V1 FIELD BUSCOUPLER 12 MBaud 750-333 Datenbogen

26  •

2001-02-27

The station address (decimal) is determined using two rotary switches on the
electronic module.

Fig. 3-5: Setting the station address

g012102d

The switch „x1“ determines the units position of the address. The switch
„x10“ determines the tens positions of the address. Valid station addresses are
between 1 and 99. The coupler also permits the station address 0.

The station address is taken over by the fieldbus coupler after switching on the
device (initialisation phase). Adjustments of the switch have no effect during
operation.

The configuration interface used for the communication with WAGO-I/O-
CHECK or for firmware upload is located behind the cover flap.

Klappe

öffnen

Fig. 3-6: Configuration interface

g01xx06d

The communication cable (750-920) is connected to the 4 pole header.