Wago 750-333 PROFIBUS DP/V1 FIELD BUSCOUPLER 12 MBaud 750-333 Datenbogen
Produktcode
750-333
Fieldbus coupler / controller
• 81
Fieldbus Controller 750-833
WAGO-I/O-SYSTEM 750
D R A F T
PROFIBUS
2001-02-27
3.2.2.5 Station
address
The station address is determined via two decimal rotary switches on the elec-
tronic module.
tronic module.
x10
01
23
456
78
9
ADDRESS
x1
01
23
456
78
9
Fig. 3-16: Creating the station address
g012102d
The switch „x1“ determines the unit position of the address. The switch „x10“
determines the tens position of the address. Valid station addresses lie between
1 and 99.
determines the tens position of the address. Valid station addresses lie between
1 and 99.
The station address is taken over by the fieldbus coupler after switching on the
device (initialisation phase). Adjustments to the switch during operation have
no effect.
device (initialisation phase). Adjustments to the switch during operation have
no effect.
Note
After Power-On the station address 0 causes the run-up of the controller and
start of the PLC functions, without the fieldbus being active.
Using this function an autarcic small scale control can be realised using the
WAGO-I/O-SYSTEM 750
After Power-On the station address 0 causes the run-up of the controller and
start of the PLC functions, without the fieldbus being active.
Using this function an autarcic small scale control can be realised using the
WAGO-I/O-SYSTEM 750
3.2.2.6
Configuration and programming interface
The configuration and programming interface is located behind the cover flap.
This is used to communicate with WAGO-I/O-CHECK and WAGO-I/O-PRO
as well as for firmware uploading.
This is used to communicate with WAGO-I/O-CHECK and WAGO-I/O-PRO
as well as for firmware uploading.
Konfigurations- und
Programmierschnittstelle
Fig. 3-17: Configuration interface
g01xx07d
The communication cable (750-920) is connected to the 4 pole male header.