Nkk Switches Slide switchesSS12SDP2LE SS12SDP2LE Datenbogen
Produktcode
SS12SDP2LE
H
Series SS
Ultra-Miniature Illuminated Slides
www.nkk.com
H50
Indicators
Accessories
Supplement
Tactiles
Keylocks
Rotaries
Pushbuttons
Illuminated PB
Slides
Programmable
Rockers
Touch
Tilt
Toggles
Electrical Capacity (Resistive Load)
Power Level:
0.1A @ 30V DC
Other Ratings
Contact Resistance: 20 milliohms maximum
Insulation Resistance:
100 megohms minimum @ 500V DC
Dielectric Strength:
500V AC minimum 1 minute minimum
Mechanical Life:
10,000 operations minimum
Electrical Life:
10,000 operations minimum
Contact Timing:
Shorting (make-before-break)
Total Travel: .079” (2.0mm)
Materials & Finishes
Actuator:
Polyacetal
Upper Case:
Polyacetal
Lower Case:
Glass fiber reinforced polyester
Movable Contactor:
Phosphor bronze with silver plating
Interior Base:
Phenolic resin (thermoset)
Terminals:
Brass with silver plating over copper plating
Environmental Data
Operating Temp Range:
–15°C through +60°C (+5°F through +140°F)
Humidity:
90 ~ 95% humidity for 96 hours @ 40°C (104°F)
Vibration:
10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range
& returning in 1 minute; 3 right angled directions for 2 hours
Shock:
50G (490m/s
2
) acceleration (tested in 6 right angled directions, with 5 shocks in each direction)
PCB Processing
Soldering: Wave Soldering: For non-supported through-hole, see Profile B in Supplement section.
For supported through-hole, 5 seconds maximum @ 250°C maximum.
Manual Soldering: See Profile B in Supplement section.
Cleaning:
These devices are not process sealed. Hand clean locally using alcohol based solution.
Standards & Certifications
The SS series devices have not been tested for UL recognition and CSA certification.
These switches are designed for use in a low-voltage, low-current circuit.
When used as intended in a low-voltage, low-current circuit, the results do not produce
hazardous energy.
General
Specifications