Benq TW526 9H.JCH77.14E Datenbogen

Operation

35

Shutting down the projector

1.

Press  

POWER and a confirmation message will display prompting you. 

If you don't respond in a few seconds, the message will disappear.

2.

Press  

POWER a second time. The POWER indicator light flashes orange, 

the projection lamp shuts down, and the fans will continue to run for approximately 
90 seconds to cool down the projector.

To protect the lamp, the projector will not respond to any commands during the cooling process.
To shorten the cooling time, you can also activate the Quick cooling function. See 

 

for details.

3.

Once the cooling process finishes, a "Power Off 
Ring Tone" will be heard. The POWER indicator 
light is a steady orange and fans stop. Disconnect 
the power cord from the power outlet.

• 

To turn off the power ring tone, see 

 for details.

• 

If the projector is not properly shut down, to protect the lamp, 

when you attempt to re-start the projector, the fans will run for a 
few minutes to cool down. Press   POWER again to start the 
projector after the fans stop and the POWER indicator light 

turns orange.

• 

Lamp life results will vary depending on environmental conditions 

and usage.

Direct power off

The AC power cord can be pulled out right after the projector is turned off. To protect 

the lamp, wait about 10 minutes before re-starting the projector. (When you attempt to 

re-start the projector, the fans may run for a few minutes to cool down. In such cases, 
press   POWER again to start the projector after the fans stop and the POWER 

indicator light turns orange.)