Whd Switch box accessoriesInfrared remote control for installation radio set Grey 112-001-00-007-04 Datenbogen

Technische Information / Technical Information

 

 

 

   Technische Änderungen vorbehalten Technical modifications reserved 06/10

 

 

You can switch it ON by pushing one of the station buttons (

1-9) 

or the “

On/Off” key.

 

 

 

Starting with “

ON/OFF” key: 

Settings before the device was switched off  are restored. 

The Stand by /power LED is on. 

The station search and saving can be done by following either of the two options: 

1.  Search the station with the button „

Scan“;  

 the closest station shows up. (I) 

 

You can adapt the quality by pushing „

Mem“  

 and immediately after that by 
 pushing the „

0“ button. (II) 

 Now, you set the frequency with the  „

Volume +/-“ buttons. (III)  

 After approximately 2 seconds with no action, the item sets 
 the buttons „

Volume +/-“ back to loud/soft automatically. 

 

2.  Set the station directly with the „

Freq“ button; 

 the direct frequency (e.g. 94,3) 
 can be set with the numeric buttons  (9-4-3) 
 and confirmed by pressing „

Freq“. 

       To save, press „

Mem“ and select the memory number  with the numeric buttons.  

 

  3.  

Autoscan 

       The station search and saving is done automatically by pressing the “Mem” and “Scan” keys.  
 

The volume can be regulated in 32 steps by pressing the “

Volume”  keys. It will be saved  

on using the „

On/ Off“ button. 

 

By pushing the „Beep“ button, you can either control the „beep“ or turn it off. 

 

The device can be programmed in the following way. 
Devive shall be muted : Push the “

Freq” button and then three times the “2” , after that  

the “

0”button. 

Device shall start with the present volume and present memory  :  
Push the “

Freq” button and  then three times the “2” button , after that the “1” button. 

Note : changes will be stored after 10 seconds. 

 
F: Changing the battery 

Press the lever ( 1 ) and pull out the battery carrier (2 ). 
Use only adequate batteries , e.g. 
Lithium  3V  CR 2025 
 

 

G.  
If the radio does not behave properly , switch off the supply voltage for some time. 

 

 

 

 

1 

2