Secuself Wireless repeater EL-2635 / E8US019RPT0A EL-2635 / E8US019RPT0A Datenbogen
Produktcode
EL-2635 / E8US019RPT0A
4
EL-2635 Repeater & Programming keypad – Repeater & Programierbedienteil – Repeteur & Clavier –
Repeater & Keypad
Conrad No: 1276483 & 1276484
Connect the Programming Keypad (EL2635-P) to the Programming
Keypad (EL2635-P) connector.
Keypad (EL2635-P) connector.
Note: The Programming Keypad (EL2635-P) is not able to operate on
battery power only.
battery power only.
8. Test the repeater from the required mounting location before permanently
mounting the unit.
9. Mount the base to the wall using four screws and replace the front cover.
When the tamper switch is open, the bi-
color LED provides indication regarding
repeater transmission and reception as
an aid during the installation procedure
– see Table 1. When the tamper switch
is closed, the bi-color LED provides
indication regarding power status
color LED provides indication regarding
repeater transmission and reception as
an aid during the installation procedure
– see Table 1. When the tamper switch
is closed, the bi-color LED provides
indication regarding power status
– see
Table 2.
Table 1: LED Indication (Tamper Open)
LED Indication
Description
Steady Green
AC & Battery OK
Flashing Red
AC Loss
Flashing Orange
Low Battery
Table 2: LED Indication (Tamper Closed)
REGISTERING THE REPEATER TO
THE CONTROL PANEL
THE CONTROL PANEL
For the control panel to recognize the repeater, you
must register the repeater to the control panel.
must register the repeater to the control panel.
To register the repeater to the control panel:
1.
Set the control panel to Registration mode
as follows:
as follows:
From the Programming menu, select
Devices, Repeaters [914].
Devices, Repeaters [914].
Select the repeater you want to register
(1-4).
(1-4).
From the
repeater’s sub-menu, select
Register [#1].
2.
Send two Status transmissions from the
repeater as follows:
repeater as follows:
On the Programming Keypad (EL2635-P),
press ... until 5. STS Transmit appears on
the display.
press ... until 5. STS Transmit appears on
the display.
Press ./.
Press ./ again.
Figure 3: LCD rogramming
Keypad (EL2635-P)
LED Indication
Description
Flashing Green
Signal Reception
Flashing Red
Signal Transmission