Elro HA68S Datenbogen
HA68 QUICK GUIDE
Connect adaptor and insert batteries at control panel (9/10)
Insert batteries
Remote control
Remote control
7
PIR motion detector
13
Magnetic contact
17
Registration of remote control (27)
Press on control panel (24)
- KEY - PIN CODE (default code= 1234)
- ENTER = Display shows 1 user setup
- ENTER = 1-1 admin setup
- ENTER = Password
- KEY - PIN CODE (default code= 1234)
- ENTER = Display shows 1 user setup
- ENTER = 1-1 admin setup
- ENTER = Password
Navigate with arrow keys to 6 remote (19)
- ENTER = 6-1 learning ID
- ENTER = wait for learning
- ENTER = 6-1 learning ID
- ENTER = wait for learning
Now press OFF button on remote control
Display = learning ok = ok
Display = learning ok = ok
= time out
= pressed too late
= ID duplicate= remote control is already registered
Press and hold ESCAPE button to leave programming mode.
Remote control is now available.
Remote control is now available.
Registration of detectors (36)
Press on control panel
- KEY - PINCODE (default code=1234)-ENTER
- KEY - PINCODE (default code=1234)-ENTER
Display shows 1 user setup
Navigate with arrow keys to 3 zone setup
- ENTER = input 3-1 ser (01-36) zone selection with number keys starting
- ENTER = input 3-1 ser (01-36) zone selection with number keys starting
with 01
- ENTER = wait for learning
Now press sabotage switch on detector to be registered
Display = learning ok = ok
Display = learning ok = ok
= time out
= pressed too late
= ID duplicate= remote control is already registered
Repeat this procedure with all detectors to be registered; Combination of zones
is freely selected. Press and hold ESC button to leave programming mode.
is freely selected. Press and hold ESC button to leave programming mode.
You will find complete instructions in the manual.