C Control PRO-BOT128 + C-Control PRO 128 Unit + Voltcraft® USB programming cable Kit 190406 Benutzerhandbuch
Produktcode
190406
11
90% of the kits returned to us contain such soldering errors, cold soldering spots, the wrong solder, etc. Many a returned "masterpiece" does not
show professional soldering work.
show professional soldering work.
Therefore only use electronic solder with the label "SN 60 Pb" (60% tin and 40% lead). This solder has a resin core, which serves as fluxing agent
to protect the soldering spot from oxidation during soldering.
to protect the soldering spot from oxidation during soldering.
Other fluxing agents like soldering paste or soldering fluid, may not be used under any circumstances, as they contain acids. These
agents may destroy the circuit board and the electronic components; in addition, they are conductive and cause leakage currents
and short circuits.
agents may destroy the circuit board and the electronic components; in addition, they are conductive and cause leakage currents
and short circuits.
When soldering in the components, make sure that these are soldered in without a gap to the circuit board, unless indicated otherwise. All
excess connection wires are cut off directly above the soldering spot. As this kit partially contains very small or very close soldering spots (danger
of solder bridges), you may only use a soldering iron with a small tip here. Perform the soldering work and the assembly in a careful manner.
excess connection wires are cut off directly above the soldering spot. As this kit partially contains very small or very close soldering spots (danger
of solder bridges), you may only use a soldering iron with a small tip here. Perform the soldering work and the assembly in a careful manner.
If everything is alright up to this point, but the robot still does not work, a component may be defective. Due to countless quality controls during
production of the different components, it is actually very unlikely that e.g. a resistor or an IC is already defect upon delivery. However, excess
soldering temperatures or mechanical strain (bending of component pins) may lead to defects of a component. One single defect component
may lead to the malfunction of the robot or unforeseeable reactions/operating conditions.
production of the different components, it is actually very unlikely that e.g. a resistor or an IC is already defect upon delivery. However, excess
soldering temperatures or mechanical strain (bending of component pins) may lead to defects of a component. One single defect component
may lead to the malfunction of the robot or unforeseeable reactions/operating conditions.
If you are a beginner with respect to electronics, you best seek the advice of someone a bit more versed in this field with the necessary
measuring devices. If you do not have such an acquaintance, send the kit to our service department (well-packaged and with an exact
description of the error) together with the corresponding instruction manual to our service department. Only an exact specification of the error
allows us to perform the right repair!
measuring devices. If you do not have such an acquaintance, send the kit to our service department (well-packaged and with an exact
description of the error) together with the corresponding instruction manual to our service department. Only an exact specification of the error
allows us to perform the right repair!
An exact error description is important! Merely stating "does not work" or "defect" does not help our service department. To prevent
unnecessary call-backs and the resulting time delay, please describe your error as accurately as possible.
unnecessary call-backs and the resulting time delay, please describe your error as accurately as possible.
Also tell us a telephone number and time at which we can reach you (e.g. during the day at work).
Before this construction kit went into production, it was assembled as a prototype and tested many times. It was first released for serial
production after achieving an optimum quality with respect to function and operational safety.
production after achieving an optimum quality with respect to function and operational safety.
To ensure a certain function safety when constructing the robot, the entire construction was divided into 3 stages:
• Assembly stage I: Installing the assembly elements on the circuit board
• Assembly stage II: Sight inspection of the circuit board
• Assembly stage III: Function test and software