Reely Hendheld RC 2.4 GHz No. of channels: 4 1310036 Benutzerhandbuch
Produktcode
1310036
10
c) Setting the Control Lever Length
You can adjust the length of the control sticks, depending on
your steering habits.
To do so simply hold the bottom part of the grip (1) and turn the
To do so simply hold the bottom part of the grip (1) and turn the
upper part (2) up anti-clockwise.
You can now set the length of the control stick by turning the
You can now set the length of the control stick by turning the
bottom part of the grip.
Finally, tighten the upper part of the grip back up.
Finally, tighten the upper part of the grip back up.
11. Setting up the Receiver
a) Receiver Connection
The receiver offers the possibility of connecting 4 servos (recei-
ver output „CH1“, „CH2“, „CH3“ and „CH4“) that are later assig-
ned the following control functions in the model:
„CH1“ = Aileron/roll servo
„CH2“ = Elevator/nod servo
„CH3“ = Throttle servo or flight/drive controller
„CH4“ = Rudder/tail servo
The receiver outputs „CH5“ and „CH6“ are not used, since the
„CH1“ = Aileron/roll servo
„CH2“ = Elevator/nod servo
„CH3“ = Throttle servo or flight/drive controller
„CH4“ = Rudder/tail servo
The receiver outputs „CH5“ and „CH6“ are not used, since the
transmitter only transmits the first four channels.
At the „BAT“ connection, a battery box (1) or a receiver battery
At the „BAT“ connection, a battery box (1) or a receiver battery
with switch cable (2) is connected if no flight/speed controller
with BEC switch is used.
Important!
When using servos with high power demand, we recommend that you always use a high-current-capable
receiver battery pack.
Figure 5
Figure 4