Reely Hendheld RC 2.4 GHz No. of channels: 4 1310036 Benutzerhandbuch

To enable transmitter and receiver to work together, they must be bound by the same digital code. In the delivery state, 

transmitter and receiver are aligned with each other and can be used at once. The binding settings must be renewed 

mainly after a replacement of the transmitter or receiver or to remove any interferences.
Before you can bind the receiver to the transmitter, check if the transmitter works in the right digital code (see previous 

chapter).
To perform the binding procedure, proceed as follows:
•  Transmitter and receiver must be in direct proximity (distance 

approx. 50 cm).

•  Switch off the transmitter.
•  Disconnect any servos that may be connected from the recei-

ver.

•  Connect the enclosed programming plug (1) to the „BAT“ con-

nection of the receiver. 

•  The power supply of the receiver (receiver battery or speed 

controller with BEC) is connected to any output of the recei-

ver.

•  Switch on the receiver. The receiver LED (2) starts to flash 

quickly.

•  Press the binding button at the receiver (see also figure 1, item 

10) and keep the button pressed.

•  Switch on the transmitter with the on/off switch with the binding 

button pushed. The LED display in the transmitter starts to 

flicker.

•  When the LED in the receiver (2) flashes slowly after a few 

seconds, binding, binding has been completed.

•  Release the binding button at the transmitter.
•  Switch off the receiver and transmitter and remove the pro-

gramming plug.

•  Re-connect the servos/controllers to the receiver.
•  Check the function of the system. If the system is not working properly, perform the process again or check the 

digital code of the transmitter. 

  If you have switched the transmitter to the digital code „AFHDS“ and bind an „AFHDS“ receiver, the LED in 

the receiver will not flash slowly but be lit permanently after binding.