Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 Datenbogen

● Select the function name

and return to the Model

menu  by  touching  the 

R T N   b u t t o n . 　 O r   t h e 

H O M E / E X I T   b u t t o n   i s

pushed.

The swash mix function is used to correct the 

swash plate in the aileron (roll) direction and 

elevator (cyclic pitch) corresponding to each 

operation of each condition.

This function allows the independent rate 

adjustments for the ailerons, elevator and pitch.

● As an example, use swash mixing to correct

undesirable roll tendencies.

● For a condition which uses AIL to ELE, set this

function to ON.

 If the front of the helicopter raises during a

right roll, when the Rate 2 side is input and

the right aileron is operated, the elevator

moves to the down side. Tune by adjusting

the Rate.

 For left roll, adjust to the Rate 1 side.

 When using this function, move the cursor to

the [ACT] item and touch the RTN button to

switch to the data input mode.

 Select the ACT mode by scrolling the touch

sensor.

*The display blinks.

 Touch the RTN button to activate the mixing

and  return  to  the  cursor  mode.  (ON  is

displayed.)

 [Switch selection]
 When [ [--]] is set, the swash mixing function

is always active and operated by merely

selecting the condition.

 When setting an [ON]/[OFF] switch, move the

cursor to the [SW] item and touch the RTN

button to access the selection screen. Set

the switch and its ON position.

*For a description of the switch selection method, see the 

description at the back of this manual.

 Move the cursor to the mixing rate item you

want to correct and touch the RTN button

to switch to the data input mode. Adjust the

rate independently by scrolling the touch

sensor.

 Initial value: 0%
 Adjustment range: -100~+100%

*When the RTN button is touched for one second, the rate is 

reset to the initial value.)

 Touch the RTN button to end the adjustment

and return to the cursor mode.

 When changing the trim mode, move the

cursor to the [TRIM] item and touch the RTN

button to switch to the data input mode.

 Select ON/OFF by scrolling the touch sensor.

*The display blinks.

 Touch the RTN button to change the trim

mode  ON/OFF  and  return  to  the  cursor

mode.

*When mixing includes master side trim, select [ON] and 

when mixing does not include master trim, select [OFF].

● Select [SWASH MIX] at the Model menu

and access the setup screen shown

below by touching the RTN button.

Scrolling

● Moving cursor

● Selecting mode

● Adjusting value

● To next page

(Currently selected condition name)

●Condition selection