Smartwares 10.011.89 Wireless Surveillance System 10.011.89 Datenbogen

35

"No Signal" or "No 
Video"

‧

No Power supply to camera

→ Check power adapter and power cord connection

‧

The camera is not paired with WDVR or signal disconnected

→ Unplug camera power then plug on again to reconnect. 
→ Please refer to Pairing section in Advanced Operation chapter for 
     detail."

‧

Service out of range

→ Relocate WDVR or camera for better reception
→ Adjust antenna or use WDVR proprietary extension cable with high 
    gain antenna to improve range. Please contact the store from 
    which you made the purchase.

‧

Signal has been blocked.

→ If possible, remove major obstacles in between cameras and 
     WDVR or relocate camera/WDVR away from water tank(aquarium),
     matel covered surface(tin roof/ metal door) and brick/marble wall

Low or unstable 
streaming video

‧

Antenna directional limitation

→ Relocate WDVR or camera for better reception
→ Adjust antenna or use WDVR proprietary extension cable with high 
    gain antenna to improve range. Please contact the store from 
    which you made the purchase.

‧

Strong electromagnetic interference near by 

→ Keep working motors (hair dryer / heat fan / air conditioner / water 
     pump) or microwave oven away from the cameras and WDVR.

‧

Busy signal in air or wireless bandwidth is low

→  keep camera away from each other 3 meters or above
→  keep wifi router or hot spot away from camera
→  From [camera setup], lower the camera resolution and quality to 
     save bandwidth consumption in the air and receive more streaming 
     video.