Spektrum DX18 SPM18000 Benutzerhandbuch

SPEKTRUM DX18 • TRANSMITTER INSTRUCTION MANUAL

The DX18 features a programmable trainer function with 4 
trainer modes. The transmitter assigns the trainer function to 
Switch I. The 4 trainer modes include: 

In Inhibit, the slave transmitter must have the same program-
ming as the master transmitter (e.g., servo reversing, travel 
adjust, sub-trim, trims).

Programmable mode enables you to program the master trans-
mitter to transfer any or all individual channels when you activate 
the trainer switch. This mode is ideal for beginners learning to 
control individual channels while the master transmitter 
maintains control of all other channels.
The slave transmitter should be in PilotLink Slave mode, if 
available. It is not necessary to have model programming in the 
slave transmitter.

When Pilot Link Master is active, the slave transmitter controls 
the primary stick functions (Throttle, aileron, elevator and rudder) 
while the master maintains control of all other channels and 
functions (including dual rates and auxillary switch positions). 
PilotLink Master is ideal for complex models as the master 
transmitter maintains control of all secondary functions, for 
example fi lght modes, retracts, fl aps and brakes.

Use Slave mode when using the DX18 as a slave transmitter and 
PilotLink is active in the master transmitter.

1. Bind the master transmitter to the model.
2. Connect the trainer cord (SPM6805) to the back of the 

master transmitter.

3. Make sure the master and slave transmitter battery packs 

are fully charged.

4. Make sure the slave transmitter is powered off; the slave 

transmitter receives power when you connect the trainer 
cord.

5. Connect the trainer cord to the slave transmitter.
6. The slave transmitter screen displays information but does 

not send a signal to the model.

7. Press the trainer button on the master transmitter to transfer 

model control from the master to the slave. 

8. Release the trainer button and the master transmitter 

regains control of the model..

Allows all sticks and pots to be used as a kick point to turn on 
functions like mixes. To add a kick point:

1. Move the control stick, lever or knob to the desired kick point 

position.

2. Scroll to the desired kick point and press the scroll wheel 

once to save the selection. 

To delete a kick point, scroll to the desired kick point and press 
the Clear button.