Datalogic GRYPHON D4130 GD4130-WHK1 Datenbogen

Produktcode
GD4130-WHK1
Seite von 199
CONFIGURATION 
4.7  USB READER CONFIGURATION 
 
The USB interface is compatible with: 
 
Windows 98 (and later) 
IBM POS for Windows 
Mac OS 8.0 (and later) 
4690 Operating System 
 
 
USB Start-up 
 
As with all USB devices, upon connection, the Host performs several checks by 
communicating with the Gryphon™ Dx30. During this phase the green LED on the 
Gryphon™ Dx30 reader blinks and normal operations are suspended. Two basic 
conditions must be met before the Gryphon™ Dx30 is ready to read codes, the 
correct USB driver must be loaded and sufficient power must be supplied to the 
reader. 
 
For all systems, the correct USB driver for the default USB-KBD interface is included 
in the Host Operating System and will either be loaded automatically or will be 
suggested by the O.S. and should therefore be selected from the dialog box (the first 
time only). 
 
If the Host supplies sufficient power to the reader, the start-up phase ends correctly, 
the green LED stops blinking and the reader emits the beep OK signal. 
 
 the Host does not supply sufficient power to the reader, a dialog box will appear on 
If
the Host and the reader will be blocked (green LED continues blinking). In this case, 
disconnect the USB device cable at the Host (green LED stops blinking), connect and 
ower-up an external supply to the USB cable then
p
 reconnect the USB cable to the 
Host and close the dialog box. The reader emits the beep OK signal. You can now 
read codes. At this point you can read the USB interface configuration code 
according to your application. Load drivers from the O.S. (if requested). When 
configuring the USB-COM interface, the relevant files and drivers must be installed 
from the USB Device Installation software which can be downloaded from the web 
page http://www.datalogic.com. 
 
The reader is ready. 
 
 
27