Woodstock SHOP FOX W1821 Benutzerhandbuch

-7-

Model W1821 (For Machines Mfg. Since 3/10)

The Model W1821 mounts on most table saws that have

27" deep tables. If your table saw does not have mounting

holes for the installation of the router table, you will

need to drill and tap these holes. Also, you may have to

modify the fence rails to allow access for the router table

T-slots. Read this entire assembly section before you begin

the installation procedure below to make sure the W1821

will fit your table saw before making any modifications.

Needed for Assembly

Qty

Another Person ..................................................1

Hex Wrench 4mm ...............................................1

Hex Wrench 5mm ...............................................1

Hex Wrench 6mm ...............................................1

Wrench 10mm ...................................................1

Wrench 13mm ...................................................2

Straightedge (at least 24" long) ..............................1

To assemble and install your router table attachment,

do these steps:

1. DISCONNECT THE TABLE SAW FROM POWER!

2. Decide which of the following mounting options best

suits your needs:

— Remove the existing right wing of the saw table

and use the existing wing mounting holes to attach

the router table.

— Mount the router table to the right side of the

saw table or the existing right-hand wing. In

these cases, you will probably need to drill and

tap three M8-1.25 holes into the saw table or

wing that match those in the router table (see

Figure 4).

Tip: Use the holes in the router table as a template

for marking the mounting hole locations on the saw

table so that the router table top will mount flush

with the top of the saw table.

3. Thread the foot pad assembly into the bottom of the

support leg, as shown in

Figure 5. For now, do not

tighten the jam nut up to the leg so that you can

adjust the height of the leg in a later step.

4. Thread the support leg onto the stud on the bottom

of the router table, as shown in

Figure 6.

Saw Table

Router Table

Mounting Holes

Figure 4. Mounting holes in saw and router

tables.

Figure 5. Foot pad bolt threaded into the

support leg.

Foot Pad

Support

Leg

Jam Nut

Figure 6. Support leg threaded into the

router table.

Support

Leg

Assembly