Wayne-Dalton KEP-IV Bedienungsanleitung

To program the KEP-IV to an Opener or to

change an existing PIN:
1. With new installations, it is recommended

to program the KEP-IV before mounting to wall,

otherwise proceed to Step 2.
2. Unit can be programmed with garage door in

either up or down position.
3. Press the transmitter PROGRAM BUTTON on

DoorMaster

light fixture,

idrive

prodrive

Quantum

or Classicdrive

opener. LED will light

idrive

opener will beep once indicating that

it is ready to learn a transmitter. (See Illustration

on right)
The

idrive

and

idrive

Torsion opener will

remain in the learn mode for 30 seconds. The

DoorMaster

light fixture will remain in the learn

mode for 30 seconds. The

prodrive

, Quantum

or Classicdrive

opener will remain in learn

mode for 60 seconds.
4. Open the cover of the KEP-IV, then push the

ON/OFF/RESET button of the keyless entry. The

Keyless Entry keypad will light indicating it has

been activated and is waiting for commands

(illumination may not be visible in direct

sunlight.)
5. Press the desired four digit PIN number,

then hold the “0” key until the door moves.

(example:1-2-3-4-0). Release the “0” key.

Programming is now complete.
NOTE:

If at any time, an error was made in

entering the codes, simply press the ON/

OFF/RESET button and repeat the above

procedures.
NOTE:

One KEP-IV can be programmed

to open multiple garage door openers. To

program for additional openers, repeat steps

1 through 5 above except input a different

four digit PIN number for each additional

opener.
Only 1 PIN can be programmed to each

garage door opener.

ON/OFF/RESET

Programming KEP-IV to Opener

Programming to Opener

IDRIVE

TORSION

IDRIVE

TORQUEMASTER

DOORMASTER

QUANTUM

& CLASSIC &

PRODRIVE

PROGRAM

BUTTON

PROGRAM

BUTTON

PROGRAM

BUTTON

PROGRAM

BUTTON

Quick

Start



USE KEYPAD TO
INPUT 4 DIGIT
PIN CODE