Utica Boilers SSC Benutzerhandbuch

• This appliance is equipped with an ignition device 

which automatically lights burner. Do NOT try to 

• Before operating smell all around appliance area for 

gas. Be sure to smell next to fl oor because some gas 

is heavier than air and will settle to the fl oor.

• Use only your hand to turn the gas shutoff valve. 

Never use tools. If valve will not turn by hand, do not 

try to repair it, call a qualifi ed service technician. Force 

or attempted repair may result in fi re or explosion.

under water. Immediately call a qualifi ed service 

technician to inspect appliance and to replace any part 

of control system and any gas control which has been 

under water.

  

• Set thermostat to lowest setting.
• Turn "OFF" all electrical power to appliance.
• This appliance is equipped with an ignition device which 

automatically lights the burner. Do not try to light 

• Remove front jacket panel.
• Turn gas shutoff valve clockwise      to closed position. 

Handle should be perpendicular to gas pipe. See Figures 

2-1 and 2-2.

• Wait 5 minutes for any gas to clear. Smell for gas, 

including near fl oor. If you smell gas, STOP! Follow 

instructions on this page: “What To Do If You Smell 

Gas.” If you do not smell gas, go to next step.

• Turn gas shutoff valve counter clockwise 

  to the 

open position. Handle should be parallel to gas pipe.

• Replace front jacket panel.
• Turn "ON" electrical power to appliance.
• Set thermostat to desired setting.
• If the appliance will not operate, follow instructions TO 

TURN OFF GAS TO APPLIANCE and call your service 

technician or gas supplier.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electrical switch; do not use any 

phone in your building.

• Immediately call your gas supplier from a neighbor’s 

phone. Follow the gas supplier’s instructions. 

• If you cannot reach your gas supplier, call the fi re 

department.

  

• Set thermostat to lowest setting.
• Turn "OFF" all electric power to appliance if service is 

to be performed.

• Remove front jacket panel.
• Turn gas shutoff valve handle clockwise      to closed 

position. Handle should be perpendicular to gas pipe. 

See Figures 2-1 and 2-2.

• Replace front jacket panel.

GAS SHUTOFF 

VALVE

Gas Shutoff Valve

Gas Shutoff Valve