Vogelzang International HIGHLAND HIGH EFFIECIENCY WOODSTOVE TR003 Benutzerhandbuch

VGZ-028 / 052705.0

TR003 HIGHLANDER™

 / 

1. Uncrate the stove and remove cardboard pack-

ing and protective poly bag. Remove pedestal
base (#5) from carton. (Save cardboard for fur-
ther assembly.)

2. Remove parts from inside stove. Parts include:

Blower Assembly (#1), Pedestal Front (#4),
two (2) Pedestal Sides (#3), Pedestal Back (#2),
and Hardware Pack (#27) located inside fire-
box.
NOTE: Stove may be lightened during instal-
lation by removing fire brick. Replace firebrick
before using. There are three different sizes
brick. Note the location of each while remov-
ing or refer to illustration 1 for proper location
inside firebox.

3. Assemble pedestal using fasteners provided in

hardware pack. Attach both sides (#3) to ped-
estal front (#4) then attach pedestal back to
sides.

4. Place flattened carton on floor and place base

(#5) face side up on the carton.

5. Place pedestal assembly on top of base. Align

holes in pedestal sides with holes in the base.
Insert bolts into each hole.

6. Carefully tip the base assembly back, place a

lockwasher and thread a nut onto each bolt.
Tighten all pedestal hardware.

7. Replace the pedestal assembly to the upright

position.

8. After properly locating floor protector (fig 1,

page 4) to accomodate minimum stove clear-
ances, place pedestal in position on floor pro-
tector.

9. Carefully position stove body onto base assem-

bly. Angle brackets attached to bottom of stove
must fit inside pedestal assembly. Using self-
tapping screws, attach pedestal base to stove
using two screws on each side.
NOTE: Stove body is HEAVY. Make sure you
have adequate help to lift stove body onto ped-
estal and use proper lifting techniques.

10. Attach blower assembly (#1) to the bottom rear

of stove. Use two scres to attach blower to the
underside of stove and two screws tot attach
blower to pedestal base.

11. Route the power cord away from stove. Do not

allow the power cord to touch any hot surfaces.
Keep power cord at least 12” from stove sur-
faces.

12. Once stove is positioned, plug power cord into

a grounded 120v outlet.

1. The stove must be placed on solid concrete,

solid masonry, or when installed on a combus-
tible floor, on a listed floor protector, such as
Hy-C or Imperial Model UL 3648BK or
equivalent with 0.08 R factor. (NOTE: to cal-
culate R-value of alternative materials see page
16). The base must extend at least 18” beyond
the front of the access door, 8” to the sides of
fuel opening, and must  extend under and 2
inches beyond either side of the stove pipe if it
is elbowed towards a wall. (See figures 1 & 3
and consult local building codes and fire pro-
tection ordinances). A grouted ceramic floor
tile installed per local building code is consid-
ered a durable equivalent.