B&B Electronics Parallel Port Input/Output Converter PPIO Benutzerhandbuch
16
PPIO2899 Manual
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104
As with the function, In_Byte, the mask value is calculated by
shifting 00000001b right the same number of times as the desired
line number. Once the mask value is calculated, it is bitwise ANDed
with Output_Byte. If the resulting value is non-zero, the line is ON
and a boolean TRUE is returned, otherwise a boolean FALSE is
returned. Notice that this function gets its value from Output_Byte
that is set when we use the function, Set_Output_Bit. The value is
not read from the port.
For example:
Line_Number = 3
Output_Byte = 10101010b
00000001b
shift-right 3 (Line_Number) =
line number. Once the mask value is calculated, it is bitwise ANDed
with Output_Byte. If the resulting value is non-zero, the line is ON
and a boolean TRUE is returned, otherwise a boolean FALSE is
returned. Notice that this function gets its value from Output_Byte
that is set when we use the function, Set_Output_Bit. The value is
not read from the port.
For example:
Line_Number = 3
Output_Byte = 10101010b
00000001b
shift-right 3 (Line_Number) =
00001000b
AND
10101010b (Output_Byte)
00001000b
The function, Set_Output_Bit, sets the selected output line ON of
OFF. The function is defined as:
PROCEDURE Set_Output_Bit ( Bit_Number,Output:BYTE ) ;
BEGIN
PROCEDURE Set_Output_Bit ( Bit_Number,Output:BYTE ) ;
BEGIN
Output_Byte := ( (Output_Byte AND ( ( 1 SHL Bit_Number)
XOR $FF) ) OR (Output SHL Bit_Number) ) ;
Port [Base_Address] : = Output_Byte;
END; {Set_Output_Bit}
The variable, Output_Byte, stores the status of the output lines.
When a bit in Output_Byte is set to a one, its corresponding output
line is ON, when it is set to a zero, the line is OFF. To set a bit to the
specified status, the bit must first be cleared. To do this, 00000001b
is shifted right for the desired line number and bitwise exclusive
ORed with FFh (255 decimal, 11111111 binary) to produce a mask
value. This mask value has all bits set to one except for the desired
line. It is bitwise ANDed with Output_Byte to clear the desired bit.
Now, having cleared the bit, it can be set to the specified state.
Since the state is either a zero or one, we can shift it right for the
desired line number to get another mask value. This value is then
bitwise ORed with the cleared value to obtain the new value of
Output_Byte. The final step is to write Output_Byte to the parallel
port.
line is ON, when it is set to a zero, the line is OFF. To set a bit to the
specified status, the bit must first be cleared. To do this, 00000001b
is shifted right for the desired line number and bitwise exclusive
ORed with FFh (255 decimal, 11111111 binary) to produce a mask
value. This mask value has all bits set to one except for the desired
line. It is bitwise ANDed with Output_Byte to clear the desired bit.
Now, having cleared the bit, it can be set to the specified state.
Since the state is either a zero or one, we can shift it right for the
desired line number to get another mask value. This value is then
bitwise ORed with the cleared value to obtain the new value of
Output_Byte. The final step is to write Output_Byte to the parallel
port.