HSM 225.2 Benutzerhandbuch

Paper shredder HSM

225.2

0510

english

8. Maintenance and care

Cleaning:

• Switch off the shredder, pull out the mains

plug.

• When cleaning only use a soft cloth and a

mild soap-water solution. Never use scou-
ring agents, cleaning ﬂ uid, petroleum or
thinners.

When the cutting capacity drops or
the noise increases (Cross cut):

• Switch paper shredder off:

Tap rocker switch pos. 2.

• Spray special cutting block oil th-

rough paper feed opening across
the whole width of the cutting
system blades.

• Run cutting system backwards

(pos. 2) without feeding paper.

• Paper dust and particles are

shaken off.

7. Troubleshooting

Pa per jam

You have fed in too much paper.

• Red LED on control panel lights.
• The cutting device runs in reverse

for approx. 2 seconds automati-
cally.

• Pa per is pus hed out.
Caution!

Do not press rocker switch alter-
nately forwards/backwards (pos. 1
/ pos. 2):
Cutting unit can be damaged.

• Devices with strip cut

If the paper is too low and cannot
be taken out:
Activate the rocker switch -
pos. 2 several times brieﬂ y.

• Devices with particle cut

Pull out the paper from the paper
feed opening. Light barrier must
be free of obstacles.

• Se pa ra te pa per stack.
• Press rocker switch pos. 1.
• Feed pa per successively.

Cut material container full

• Red LED on control panel lights.
• Paper shredder switches off

Empty the cut material container,
because if it is too full, malfunc-
tions can occur in the cutting sys-
tem

• Tap rocker switch pos. 2.
• Remove full shredded material

bag and insert new bag.

Door contact interrupted

• Red LED on control panel lights.
• Paper shredder switches off.
• Check whether front door is

closed properly.

If other faults occur, please check the follo-
wing before calling our customer service:

• Is mains plug in ser ted?
• Is rocker switch tur ned on?
• Is the mo tor over lo aded?
al low mo tor to cool down for 15 - 20 min.